A Luxor grill is usually the centerpiece of a mid-size outdoor kitchen: a stainless built-in with an infrared burner and a rotisserie, set into a block or stucco island. If yours is not lighting well, is cooking unevenly, or has years of grease on it, we can work on it at your house without pulling it out of the island.
About Luxor grills
Luxor grills are sold under the A.H.T. model designation, which is where the AHT in model numbers like AHT-30RCV-BI comes from.
Spec sheets describe 304 stainless steel with welded construction, a double-lined hood, stainless U-shaped tube burners, a ceramic infrared searing burner, continuous spark ignition, and a rear infrared rotisserie burner with a rotisserie kit.
A Luxor is a straightforward grill to work on once you see how it is laid out. The burners sit in a stainless firebox, the infrared burner is a ceramic unit rather than a separate module, and the controls are mounted in a panel along the front. That simplicity helps when we trace a fault, because there are fewer hidden components between the knob and the flame.
Typical Luxor problems
With tube burners, one ceramic infrared burner and a spark system, the common issues are fairly predictable:
- Continuous spark that clicks but does not light the burner because of a dirty or worn electrode, or a wire that has lost contact.
- U-shaped tube burners with clogged ports or rust, leading to flame that lifts, yellows or goes out.
- Ceramic infrared burners, front or rear, with cracked tiles or grease-soaked surfaces that will not light cleanly.
- LED control lighting or interior lamps that have stopped working.
- Flame tamers that have burned through and no longer protect the burners from drippings.
- Gas valves and regulators that stick or leak, especially on grills that have run on propane for a long time.
Repair, step by step
We watch the grill try to light, then check spark at the electrode, gas supply and burner condition. Once the cause is clear, the part is swapped out and the system retested. A repair is not finished until each burner has been lit, the infrared burners have been run, the rotisserie burner has been run, and the flame pattern looks right with the hood open and closed. More on this is under BBQ repair.
What a Luxor cleaning involves
We take out the grates, flame tamers and burners, then scrape the firebox and hood and degrease them. The drip pan and grease path are cleaned out, burner ports opened, electrodes cleaned, and the infrared burners gently cleaned without damaging the ceramic. Finally the stainless is washed and polished with the grain. Details are on our BBQ cleaning page.
Restoring a Luxor
If cleaning will not fix it, that is when restoration applies: new burners, fresh electrodes and wiring, new flame tamers, rebuilt infrared components and refinished stainless. Photos of finished work are in the gallery, and the BBQ restoration page explains the scope.
Built-in or freestanding, and keeping it running
Most Luxor gas grills we see are built-ins, which means we work through the front of the island and from above. Luxor also makes freestanding charcoal models, which have different wear points such as grates and fireboxes rather than gas parts. For a gas built-in, brush the grates while warm, empty the grease pan, burn off residue after cooking and cover the grill. If it is part of a bigger setup, see outdoor kitchens.
Where we work
Each visit is done at the grill, with the hood open and the gas connected, because a problem that only shows up under flame cannot be judged any other way.
Our service area is all of Orange County, including Anaheim, Orange, Garden Grove, Santa Ana, Tustin, Villa Park, Lake Forest, Mission Viejo and Yorba Linda. You can start with the instant quote form and tell us about your Luxor.